WIP - Journal Notes
The scale of the top wall is making ghosty bits when I set it to the nozzle of .4mm I get .~38mm or some variant while it uses the cone module. It needs to be exact so that there are no lumps on the cutting edge.
Need to somehow replace the wall function with the below.
Left off on Test8.
Found module bevel edges.
https://github.com/hraftery/prism-chamfer
1. Copy prism-chamfer into OpenSCAD libraries
Ex: C:\Users\emily\Documents\OpenSCAD\libraries
//==============================================================================
// Include the prism-chamfer library for creating chamfers in OpenSCAD
//==============================================================================
include <prism-chamfer.scad>;
// Define parameters
scale = 1; // Scaling factor for SVG coordinates
minWallThickness = 1; // Minimum wall thickness
wallHeight = 11; // Total height of the object
nozzle = 0.4; // Desired flat edge thickness at the top after chamfer
// SVG coordinates for the outer wall (scaled)
outerWall_0 = scale * [[-0.200, 99.800], [-99.800, 99.800], [-99.800, 0.200], [-0.200, 0.200], [-0.200, 99.800]];
// Chamfer parameters
Start_edge = 0; // First edge to be chamfered (adjust as needed)
End_edge = len(outerWall_0) - 2; // Last edge to be chamfered (one less than total vertices)
Top = true; // Chamfer the top edges
// Side lengths for the chamfer
Side_length = minWallThickness - nozzle; // Calculate side length to achieve 0.4mm flat top
Enable_side2 = true; // Enable two different chamfer side lengths
Side2_length = wallHeight - 2; // Side length for the start of the taper at height-2
Corner_slope = "medium"; // Chamfer slope (adjust as needed)
// Module to create the 2D base shape from SVG points
module base_shape() {
difference() {
// Outer path
polygon(points = outerWall_0);
// Inner path (offset by thickness for wall)
offset(r = -minWallThickness) {
polygon(points = outerWall_0);
}
}
}
// Main extrusion and chamfer application
difference() {
// Extrude the base shape to the full height
linear_extrude(height = wallHeight) {
base_shape();
}
// Apply the chamfer to taper from height-2 down to the nozzle
translate([0, 0, wallHeight - 2]) {
prism_chamfer_mask(
outerWall_0,
Start_edge,
End_edge,
Top ? wallHeight - (wallHeight - 2) : wallHeight, // Chamfer starting point
Side_length,
Enable_side2 ? Side2_length : Side_length, // Dual side length for taper
Corner_slope
);
}
}
