I look through pages of free 3D files on cults3d.com looking for polymer clay cutters and added them to my cutters collection. I liked the selection on this site, so that is where I host my creations as well.
Cults3d: https://cults3d.com/en/design-collections/Kawaii_Happy_Things/free-cutters
I also found a few on Thingiverse:
https://www.thingiverse.com/kawaii_happy_things/collections/free-polymer-clay
I printed some and it was a 6-hour print. I am really curious about if the angled cutters make a difference vs ones with a single or double edge fine blade. I would think they would be less likely to have things get stuck in them, and be generally easier to clean.
Two of the prints had some lines through the center of them, but I should be able to remove them with a file. The smooth slope feels really sturdy and clean on the big loopy L3D10 clay cutter by Denislav.
No comments:
Post a Comment